LIT Urban Underglow™ System installation

LIT KIT CONTENTS

LIT KIT CONNECTED

(1) LED multicolor tube 37 inches in length (1) Power Cord with LIT controller (1) Remote Control (2) Plastic Clips adhesive backing and screws (2) Spacer Strips Accessory Items (if ordered): see LIT Accessories - Additional LED Light Tube(s) 37 inch, 20 inch, or 13 inch length option - Rechargeable Battery Packs – (4hr or 10hr charge) - LIT Jumper Wire (10ft) to extend connection between LED Light Tubes Note: Up to 16ft of additional LED Light Tubes can be connected to expand the system. That is, any combination of the 37 inch, 20 inch or 13 inch LED Light Tubes.

STEP 1: Determine the surface area (floor, wall, etc.) that you wish to illuminate by experimenting with the LED Light Tube for proper lighting effect. Connect system as in above picture.
STEP 2: Fasten (2) Plastic Clips to appropriate surface to achieve desired lighting effect. Insert the black Spacer Strips into Plastic Clips and snap in LED Light Tube.
STEP 3: Pull clear plastic strip from LIT Remote. Be sure to point LIT Remote at the white wire (with black tip) for best operation.

Underglow for sofa, futon, bed, seating, etc. (~ 8 inches from front edge)	Back lighting or wall light

LIT REMOTE OPERATION

The NEW LIT Remote has 44 buttons.  The table below represents each button on the LIT Remote Control:

Brightness +	Dimming -	Pause/Play	On/Off
Red	Green	Blue	White
Orange	(Pea Green)	Dark-Blue	Milky-White
Dark yellow	(Cyan)	Light Blue	White-Pink
Yellow	Light Blue	Pink	Green-White
Light yellow	Sky Blue	Violet	Blue-White
Red ↑	Green ↑	Blue ↑	Speed +
Red ↓	Green ↓	Blue ↓	Speed -
DIY 1 (memory/store)	DIY 2	DIY 3	Automatic change
DIY 4 (memory/store)	DIY 5	DIY 6	Flash on and off
3 color jump change	7 color jump change	3 color fade change	7 color fade change

Mixing and storing custom colors:

1. Press any DIY button (you should get a White light color when pressed for 1^st time). Since White color = Red + Green + Blue  (each at full intensity) the ↑ will not affect the color, thus; start color change by;
2. Press any of the Red ↓ or Green ↓ or Blue ↓ buttons  (you can add color back by pressing the ↑ button)
3. Press the DIY button again to store the color for recall.  You can store up to 6 custom colors.

Click here to learn how mixing Red, Green, and Blue can create millions of colors.  Drag the red, green and blue squares on top of each other then use the slider bars to see how adding or removing red, green, and blue you can create any color.

LIT flat panel TV installation: